Saturday, April 13, 2024
Home xin Meggies vacuum machine doesn’t pump air in the bag today! How to put the bag

Meggies vacuum machine doesn’t pump air in the bag today! How to put the bag

by admin
0 comment

disassemble the bottom screw to see if there is a spring at the bottom left and if the cushion is worn or eaten by insects. If it is to cut a plastic cushion of similar size and thickness, it will be good

the internal pumping vacuum machine is composed of vacuum pump, vacuum chamber, heating transformer, heating table, plexiglass plate upper cover, air bag, solenoid valve, time relay, power indicator, air switch, vacuum meter, gear switch, emergency stop switch, AC contactor, etc

it can draw the air out of the vacuum bag and seal the opening of the plastic bag firmly. The chuangmeng vacuum machine is suitable for all kinds of food and electronic products

banner

Vacuum Packaging:

concept definition

vacuum packaging is to put food into the packaging bag, extract the gas in the packaging bag, and complete the sealing and embossing process at one time after reaching the predetermined vacuum degree

Vacuum inflatable packaging put the food into the packaging bag, extract the air in the packaging bag to reach the predetermined vacuum, then fill it with nitrogen or other mixed gas, and finally complete the sealing and embossing process at one time. Fill the product with gas (puffed food, bread, fish fillets, etc.)

external pumping vacuum machine

there are some conditions conducive to preservation, such as compression resistance, crushing resistance, gas blocking, fresh preservation, keeping food dry and so on

disassemble the bottom screw to see if there is a spring at the bottom left and if the cushion is worn or eaten by insects. If it is to cut a plastic cushion of similar size and thickness, it will be good. Don’t thank me. You can try something bad

I. the whole machine does not work:
a. the voltage is too low and the fuse is blown out
B. the travel switch is misaligned
C. the pump or motor is stuck
D. the plug-in of the vacuum delay device is loose or damaged
Troubleshooting:
use the voltage regulator, replace the fuse, adjust the position of the travel switch, find out the cause of the fault, plug in the delay device or replace
II The vacuum cannot be pumped up:
a. the vacuum pump reverses
B. the vacuum solenoid valve does not work
C. whether the vacuum pump oil is sufficient or needs to be replaced
Troubleshooting:
adjust the control circuit of any two check valves in the motor phase line, repair or replace the solenoid valve

You may also like

Leave a Comment

Soledad is the Best Newspaper and Magazine WordPress Theme with tons of options and demos ready to import. This theme is perfect for blogs and excellent for online stores, news, magazine or review sites.

Buy Soledad now!

Edtior's Picks

Latest Articles

u00a92022u00a0Soledad.u00a0All Right Reserved. Designed and Developed byu00a0Penci Design.